Dear all,
A new version of digital firmware for InBody 770 is available for use and can be downloaded here : https://www.dropbox.com/sh/3rrx8a06rkidb4b/AAApjYRQWiXmqlruONiogilsa?dl=0
The following changes have been applied :
1. (request 22-0433) Add phantom printer (US corporation request) - Add phantom printer to printable printer list. (Kernel needs to be 1006)
2. (Request 22-0235) Japanese SMI text correction - Corrected the wording of the selection screen on the right side of the LCD and the image of the result sheet.
3. (request 22-0389) When setting Spain-Mexico, amended to save the customer center information of the Mexican corporation.
4. (Request 22-0278) Load cell calibration result pass/fail criteria added (requested by the Ministry of Production) - When performing load cell calibration during production without setting 0kg, the initial value is recorded as -nan. At this time, it is displayed in red on the QC Report screen.
6. (Request 22-0457) Added a function that does not reset country/language settings when setup is initialized at the request of the production department - Setup2 initialization is added under the existing Setup initialization after entering initialize in Test Mode
7. (request 22-0457) Fixed the problem of audio being cut off on the posture screen in Spain and Mexico
8. (request 22-0562) added country - Cyprus, Croatia, Slovenia, Tunisia, Albania, Macedonia, Kenya, Malta, Moldova, Pakistan, Palestine, Jordan, Libya, Oman, Bahrain, Kuwait, Qatar, Iraq, Yemen, Philippines, Brunei, Myanmar, Mongolia